Master cylinder compression fitting conversion

[kevinbmx77]

Ive watched this video several times, it shows the part but no parts number. Can anyone give me a link to this fitting please? https://m.youtube.com/watch?v=JDGGSxEE5a0

Sent from my SM-G920P using Tapatalk

 

[Jbrown1238]

Ive watched this video several times, it shows the part but no parts number. Can anyone give me a link to this fitting please? https://m.youtube.com/watch?v=JDGGSxEE5a0

Sent from my SM-G920P using Tapatalk

I can't remember the exact part number, I do know I used a Russell brand piece and it was a common thread. You may find a picture of it still in the original packaging somewhere in my build thread.

http://www.therangerstation.com/forums/showthread.php?t=93941

 

[kevinbmx77]

I can't remember the exact part number, I do know I used a Russell brand piece and it was a common thread. You may find a picture of it still in the original packaging somewhere in my build thread.

http://www.therangerstation.com/forums/showthread.php?t=93941

Did the ones you use look like this? http://m.summitracing.com/parts/rus-640281 i think the quick disconnect connects to this and it screw into any slave. If thats the case i can reuse the stock line and all

Sent from my SM-G920P using Tapatalk

 

[Jbrown1238]

Did the ones you use look like this? http://m.summitracing.com/parts/rus-640281 i think the quick disconnect connects to this and it screw into any slave. If thats the case i can reuse the stock line and all

Sent from my SM-G920P using Tapatalk

Yep, it looked just like that. I pushed it in and drove the roll pin through and it was done.

 

[kevinbmx77]

Yep, it looked just like that. I pushed it in and drove the roll pin through and it was done.

Sweet, thanks for the help

Sent from my SM-G920P using Tapatalk