GougedGeek
New Member
Anybody have any tips on getting the transfer case linkage adjusted on my 94 B3000. It will work in 2H and 4L but 4h needs the adjustment. Thanks
-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
Manual Transfer case adjustment
- Thread starter GougedGeek
- Start date
Wicked_Sludge
Well-Known Member
loosen the slider bolt (the smaller one i believe).
shift the case into 4 low.
slide the cam plate up until the shift lever is about 1/8-1/4" from touching the plate.
tighten slider bolt.
shift the case into 4 low.
slide the cam plate up until the shift lever is about 1/8-1/4" from touching the plate.
tighten slider bolt.
Sponsored Ad
Sponsored Ad
TRS Events
Member & Vendor Upgrades
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
Recently Featured
Ranger Adventure Video
TRS Merchandise
Follow TRS On Instagram
