mrecoolgar
Well-Known Member
The flat rubber seal screwed to the floorboard. Mine is ripped. Please see photo.
-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
Wanted Manual Trans Floor Boot Seal
- Thread starter mrecoolgar
- Start date
- Joined
- Oct 24, 2012
- Messages
- 4,726
- Age
- 35
- City
- Lafayette
- State - Country
- TN - USA
- Vehicle Year
- 1988
- Vehicle
- Ford Ranger
- Drive
- 4WD
- Engine
- 4.0 V6
- Transmission
- Manual
- Tire Size
- 245-70-R16
That doesn't look like anything I've seen factory in a Ranger. Granted I'm not up on newer models than about 90...
But, universal shifter boots do look like that. Finding one that fits the same screw holes might be difficult though. Good luck
But, universal shifter boots do look like that. Finding one that fits the same screw holes might be difficult though. Good luck
- Joined
- Sep 21, 2007
- Messages
- 1,737
- City
- Wa, Bremerton 98310
- Vehicle Year
- 1987
- Total Lift
- Ranger 5" (1½" Hiryder/3" body), BII 4" Procomp
- Total Drop
- Ranger 5sp, BII A4LD
- Tire Size
- Ranger 32"/4:10LS, BII 33"/3:73LS
- My credo
- Deengineer until it is how Blue Oval should have sold it!!
mrecoolgar,
If the seat in the pic is part of a set in your rig, you are one lucky driver.
If the seat in the pic is part of a set in your rig, you are one lucky driver.
Sponsored Ad
Sponsored Ad
TRS Events
Member & Vendor Upgrades
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
Recently Featured
Ranger Adventure Video
TRS Merchandise
Follow TRS On Instagram
