Welcome Visitor! Please take a few seconds and deadbeat
Well-Known Member
- Joined
- Aug 10, 2007
- Messages
- 69
Just got a set of 1988 power doors off a ranger. I pulled the whole harness including the fuse panel and all the way across to the large round connector at the drivers side firewall. The question is, on my 1990 ranger, do I have to change this whole harness out or can I just pull what I need? The reason I dont want to change the whole thing is that a few wires were cut before I got to it and it has two horns and I only have one, and everyone else talks about installing a fuse, but if you used the whole harness and fuse panel off the donor vehicle, shouldnt it already have a fuse in place? Any help would be appreciated.
