• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

Manual Shift Knobs


Of course now I need a decent picture I can't find one, this is the best I can dig up:

129_0301_14z+2003_ford_ranger+front_interior_view.jpg


Maybe a FX4 owner that has one can get a better picture of it?
 
My 8 ball would not stick ..got mad one good whack from the base of a 1 lb hammer took care of that!!!
 
8 Ball on a splined shaft. Drill the 8-ball 1/16 to 1/10 inch smaller than the outer spline diameter. Use a hammer and a 2x4 (to protect finish) and tap it onto the shift stick. No glue, no mess, stays tight.
 

Sponsored Ad


Sponsored Ad

TRS Events

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Ranger Adventure Video

TRS Merchandise

Follow TRS On Instagram

TRS Sponsors


Sponsored Ad


Sponsored Ad


Amazon Deals

Sponsored Ad

Back
Top