Manual hub O rings

[Wild Bill]

Can anyone give me a source for the o ring that seals the ford manual hub to the rotor? ( other than the dealer ). Ive tried searching this forum but haven't come up with anything. Just curious, Ive had my 1990 Ranger for 7 years and have no complaints with the original manual hubs. Why are there so many aftermarket hubs?

 

[chrwilkins30]

You could prob call warn and get the seal. They have great custoner service and will prob help you out. But really you don't need that seal. I onow of a few people who dont even use them without a problem.

 

[88_Eddie]

pretty sure i found one at autozone, i remember replacing them. i'll try and find it

edit-well i cant find it on their site, may have gotten in from rock auto but i dont recall, it was a while ago

 

[87stx]

Napa part # 727-2153 i think, check and see. I think they was 1.70 ea.

 

[UrbanRedneckKid]

I just use silicone/ RTV.

There are so many aftermarket hubs, because when they are used hard they strip or grenade. They are fine for light off-road, driving on snowy roads, pulling a boat out, or anything else a grandpa might use 4wd for.

 

[Wild Bill]

O ring

Got it! That NAPA part # was good- Thanks a bunch- WB