Welcome Visitor! Please take a few seconds and bigredneck61088
Member
I have a 1998 ranger, 4.0, 5 spd (m5od), and 4 wheel drive. The clutch has less then 30,000 on it, along with the throwout bearing, pilot bearing, and pressure plate. The truck drives fine, clutch grabs fine, fluid full, however on a downshift the truck jerks like something is not catching. Also, once in a while the truck will go into gear, make a scraping noise until the gas is hit... It only has these issues on the downshift, not a hard upshift, Any ideas??? Clutch has worked great the last 30,000 and this just started yesterday, its got me stumped
