Light Tab Blueprint?

[dwsykes]

Does anyone have a blueprint for the light tabs I see up here? I'm talking about the ones like Underdog performance makes. I'm thinking about making some out of stainless steel, and all I need to make it easy is to have a blueprint. Thanks in advance!

 

[02RangerXLT]

Look at this link:

http://therangerstation.com/forums/showthread.php?p=607977#post607977

There really isn't much of a blueprint to them... its just an angle bracket... all you'd really need to make your own is a tape measure, a ruler, and whatever material you decide to use...

 

[dwsykes]

Yeah, I've seen this thread. It is where I was looking earlier. All I really need to know is the hole size, total length/width, and where to bend. I have access to a water jet and press to make it nice and purdy.

 

[02RangerXLT]

Yeah, I've seen this thread. It is where I was looking earlier. All I really need to know is the hole size, total length/width, and where to bend. I have access to a water jet and press to make it nice and purdy.

I'm just shooting in the dark here but... those holes are the regular size as most light bolts... thats either 3/8" or 1/2", I forget which... but drill them to whatever size bolt YOUR lights have...

The shorter end of the angle bracket appears to be around 1" to 1.5"... the longer part appears to be around 2.5" to 3.5".

In the end, as I said, build the brackets how you want them to be, hell, make some "mock-ups" out of cardboard and go from there.

 

[dwsykes]

had computer problems....
Thanks, that is just about what I needed. I will take your advice on the cardboard. Thanks again everyone!