• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

Issues with a sagging box


91oldblue

Active Member
Joined
Jan 4, 2010
Messages
27
Vehicle Year
1991
1996
Transmission
Manual
my 2wd rangers back end is sitting lower than the front, other than the fact that it looks really stupid, when i put anythign over 100lbs in the back it bottoms out.
also i would like the back to sit a little bit higher than the front
is this a problem with my leafs?
and recommendations?:dunno:
 
Yeah, swap in another set of packs, or if you want a little lift get a set from an Explorer.
 
I had that problem with my Ranger... Since I was using it like an F-250 most of the time, I built my own leaf packs for it. Gave it a lil lift... enough that I had to use shocks off of a 4x4 Ranger. But I loved it, I could load it down without bottoming out.
 
sounds like a personal problem. Might be a surgeon that can take care of that.
 
And make sure your shackle mounts don't look like this:

P1011344.jpg


P1011345.jpg


P1011346.jpg


My drivers side was actually riding on the bottom of the bed at that point. O.o I found replacement shackle mounts on ebay, but it turns out they are made by Dorman. I can grab you a part number if you need it.
 

Sponsored Ad


Sponsored Ad

TRS Events

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Latest posts

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Ranger Adventure Video

TRS Merchandise

Follow TRS On Instagram

TRS Sponsors


Sponsored Ad


Sponsored Ad


Amazon Deals

Sponsored Ad

Back
Top