Is there a list of seats that will fit in a ranger???

[Jwad00]

Hey guys was there once a huge list of seats out of different cars that would fit into a ranger?

 

[03Fx4MN]

Tech section Clicky

 

[Jwad00]

Wasn't there like a huge list at one time though? That only has like 5 cars listed....

 

[Insanejughead]

I remember what you're talking about Jason. I can't seem to remember where I seen it offhand...

 

[feellnfroggy]

Your would prolly likethe ford probe gt seats from 93-97. Or the mazda mx-6 same car different design, But for a street truck like yours I would def shell out the bux for 03-04 mustang cobra seats. Unless your a big guy. Exploder buckets are the nicest and easiest swap. Everything else will prolly involve swapping rails. FoxBody mustang GT seats are pretty sweet too.

 

[Insanejughead]

Yeah, he's done the explorer seat swaps. He's just curious about the list of (I think) 20 different cars in which seats could work in rangers. I know I've seen it myself, but it's been a few years since I was interested in anything dealing with seats and swaps.

 

[86rangerxlt]

anyone put ford ford taurus seats in a ranger? wondered if it would work. i got the drivers seat for free and its in dam good condition... its electric too

 

[Jwad00]

Hmm deng that sux. And I am looking for my 99 4wd. I don't have the lowered one anymore. Sold it back to my dad. I was actually looking at lincoln LS seats but didn't know if they would work.

And I'm not sure about the taurus seats

 

[86rangerxlt]

well once i get around to putting em in ill let everyone know what had to be done or if it was a straight bolt up.

 

[3.0ranger1227]

Are all the ranger seat mounting points the same? I'm looking to swap my stock 60/40 for a set of buckets, but we're not sure whether or not the holes in the cab floor are the same. he has an 98 and I have an 03 . we would have to switch the whole frame because his seats are welded to the stock frame.

 

[doyouquaxu]

Are all the ranger seat mounting points the same? I'm looking to swap my stock 60/40 for a set of buckets, but we're not sure whether or not the holes in the cab floor are the same. he has an I-beam ranger(i'm trying to find the year right now, but its around a 95ish) and I have an 03 A-Arm. we would have to switch the whole frame because his seats are welded to the stock frame.

carlos' truck is a-armed fool. it's a 98

 

[3.0ranger1227]

Thats a my bad.. i thought he had an earlier one...

we figured out that the std and ext cab floors are different

 

[Stinger427]

Would you guys happen to know if the seats from a 93 ford van would work? they're buckets.