Welcome Visitor! Please take a few seconds and 
RobinHood
Well-Known Member
AS l am swapping in my new aluminum one pirce driveshaft, my smaller 2.5 yoke breaks on me. So l am headed to the junkyard Monday but had a question...
Is the output flange on the 8.8 axle (the 3" one) interchangeable with the flange on the BW1354 electric transfer case? Can l take the flange from a junkyrad 8.8 that is 3", remove the 2.5 flange from my transfer case, then bolt the 3" flange from the 8.8 in its location?
Or does the flange on the transfer case have to be from a transfer case?
Is the output flange on the 8.8 axle (the 3" one) interchangeable with the flange on the BW1354 electric transfer case? Can l take the flange from a junkyrad 8.8 that is 3", remove the 2.5 flange from my transfer case, then bolt the 3" flange from the 8.8 in its location?
Or does the flange on the transfer case have to be from a transfer case?
