How do I test the Engine Control Module?

[Jim2]

I have an extra one, and I want to sell it.. if it's good.

These things bring good money on eBay...
http://www.ebay.com/itm/88-FORD-RAN...66758?item=350473766758&vxp=mtr#ht_1028wt_933

I guess I could just plug it in and see if the truck runs, but I don't know if that would be a thorough enough test because I already undid a lot of the wires in the dash.

I'm stripping this truck for the track, and most of the dash is already ripped out. The gages are out, as well as anything else I could remove.
The ignition is replaced by a kill switch, with a push-button for the starter.

Is there a way to test it with a multi-meter?

 

[CHKNFKR]

take it in to advance auto parts if there is one near you. they can run a full diagnostic on it free of charge.

 

[Jim2]

take it in to advance auto parts if there is one near you. they can run a full diagnostic on it free of charge.

We don't have that store on this island, but we got Napa, O'Rielly's, etc.. I guess I'll call them up and see.. Thanks!

 

[CHKNFKR]

i'd think just about any parts store should be able to test it for ya.