Welcome Visitor! Please take a few seconds and bobdog301
Active Member
help, i have a 95 2.3 ranger 5speed clutch slave and bering replaced 2 yrs ago (75,000) by aamco. lately i have had to top off res.last 1 month so i know i have a leak, today i was leavin for work and the pedal went hard would not go to the floor and would not engague not even grind , i blead the system through the bleeder worked fine for about 15-20 pumps than went back to not goin to the floor and hard, i know about engines but tranny's not my strong point does anyone have any ideas where to start seems bleeding fixes problem for short time could it be master cyl. i think mine is in the tranny....CRAP
