• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

H


Trying to find info about interchange. Will a 91 3.0. Fit into a 98 3.o truck without a bunch of hassel
20191207_132511.jpg
 
Doubt it.

Youre going from OBD II to OBD I and going from EDIS to a distributor.

Welcome to trs!
 
Yeah, that electronical stuff is always the PITA. Fit - YES, without a bunch of hassles - NO.
 
You can use the 1991 Long Block(block with heads attached)
You need to swap over the 1998 front engine cover and crank pulley(for crank sensor), the upper and lower intakes(for fuel and sensor systems), to the 1991 long block
Also swap over the Cam sensor and synchro to replace 1991 distributor

So quite a few parts
For a more direct swap you would need a 1998-2008 3.0l Ranger or B3000 engine, but would still need to change some sensors most likely

Beside the OBD and spark system differences the Fuel system changed in 1998 and up Rangers
 

Sponsored Ad


Sponsored Ad

TRS Events

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Ranger Adventure Video

TRS Merchandise

Follow TRS On Instagram

TRS Sponsors


Sponsored Ad


Sponsored Ad


Amazon Deals

Sponsored Ad

Back
Top