Drove through some water this weekend while wheeling. Afterward I no longer had a tach or indicator lights for my ebrake and 4x4. Checked fuses. Any ideas on what could have happened? I didn't think the wiring for both would be tied together.
-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
Got a problem with indicator lamps and tach
- Thread starter disciplerocks
- Start date
hondaxr650
Well-Known Member
According to my wiring diagram, your 4x4 indicators, instrument cluster warning indicators and tach all run off of fuse 16. But it also looks like your fuel, temp and volt gauges run off of it too , so they would be dead if the fuse was bad.
Yeah I checked all my fuses after it happened. Its not that. Any other ideas?
Ok so I noticed when I turn my key on, the check engine light still comes on so I am only missing the 4x4 and ebrake lights along with the tach. Anybody?
strvger
Well-Known Member
- Joined
- Feb 25, 2009
- Messages
- 3,013
- Vehicle Year
- 1997
- Transmission
- Manual
as you were wheeling, maybe check for loose wires, hot and ground. also, might see if there are any fusible links that might have done their job in the water. just my guess.
Still not seeing anything. No one knows where these two tie together?
Sponsored Ad
Sponsored Ad
TRS Events
Member & Vendor Upgrades
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
Recently Featured
Ranger Adventure Video
TRS Merchandise
Follow TRS On Instagram
