Full size bronco axles on a Bronco II

[The Jester Race]

I'm sure it can be done, my question is how hard would it be to do? Also if I do this swap what are my options for lifts? Would I still be looking for B2 lifts or would I look for full size bronco lifts or am I looking at building a custom lift? I'm looking for a wider stance.

Any thoughts? Advice?

-Jester

 

[swamprat]

There is plenty of info in the forums if yoy do a little search. Yes it can be done and has been done by many people here at TRS. You are looking at a little fabrication. There are some good threads about what springs to use and how much lift can be expected.

 

[alaskan155]

for the rear look at bIV his has the f150(which should be the same as the bronco leaves) for the rear

78-79 broncos would be the best donors
70s f-150 and 250s would be next

and if you want ttb
http://www.autofab.com/mdl_44_ranger.htm