• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

Erratic steering wheel 08 ranger


Yamaharx-1

New Member
Joined
Jan 18, 2015
Messages
4
Vehicle Year
2008
Transmission
Manual
Hi, I replaced the rack and pinion in my 08 4wd ranger. When it was completed I filled the fluid reservoir and started the truck. The steering wheel went crazy erratic side to side jumping back and forth. It's so strong it's hard to hold straight. Any ideas?
Thanks
 
full of air you need to drive it around in circles in a big parking lot to remove the air.
 
The steering wheel bangs back and forth so bad you can't even drive it. Can it be a bad rack or no?
 
Did you center the rack before installing it?
 
I believe so but what is the procedure for it? Once in I made sure that there was equal length threads on each side before the tie rods.
 
To center a steering gear you lock some vice-grips onto the input, turn it all the way to one side, turn it all the way back to the other side while counting the number of turns, then turn it back the first direction half the number of your count.

So an example would be turn it to the left as far as it goes, turn it back right while counting, say it goes 4 turns, then turn it back to the left 2 turns.
 
Thanks, I will try that and see what happens. Imagine I should just pull it out and start from the beginning again?
 

Sponsored Ad


Sponsored Ad

TRS Events

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Ranger Adventure Video

TRS Merchandise

Follow TRS On Instagram

TRS Sponsors


Sponsored Ad


Sponsored Ad


Amazon Deals

Sponsored Ad

Back
Top