Easiest way to bleed a clutch 86 ford ranger

[kingkevo85]

I already installed it (repaired the broken one) Was to pup it while its the truck is off and keep filling with brake fluid. The air looks like its coming out but clutch is still going to the floor when pumped. Did it for about an hour. Any other ways to where I won't have to take it all off? thanks guys

 

[Spott]

If there's air in the master cylinder, you'll have to take that off the firewall to bleed it properly. Once the master is bled, you can bleed the slave in place without removing the transmission, but don't let the reservoir run dry while bleeding or you'll have to pull the master again.