driveshaft front flange or ujoint?

[crawlin91]

Ive searched other threads and tech info but I wonder....do I just need a conversion u-joint to make this work? I suppose it could go either way (tcase flange or forward ujoint piece) but I dont really have time to go and dig at the yard for this one.
Im doing the swap to the single piece driveshaft (must be aluminum, its light) this friday. the front and rear are both large flanges. 3 1/2" center to center for the bolt pattern and about 4" across. well my T case accepts the 2.5" bolt pattern flange.
I read something about a 1310-1330 is that what I need.
Thanks guys.

 

[crawlin91]

anyone? here it is....if I was to go the flange route. bout halfway down the page no part #s though
http://www.therangerstation.com/forums/showthread.php?t=12979&page=14

 

[crawlin91]

bump

 

[alaskan155]

http://www.fordracingparts.com/parts/part_details.asp?PartKeyField=262

thats what i plan on running till an 8.8 swap with my fs bronco DS to 7.5 rear

 

[crawlin91]

thank you. if the driveline shop doesnt have a flange thats what I will have to get.