Doubler shaft interest

[maddyn]

Hey all,

I along with a couple friends are looking into getting a couple torque doubler shafts made and we can get a better price on 10+. We were wondering how much interest there would be for these? Right now we're getting a prototype made, and and soon as we find out if that works we'll give the go ahead to make more. They're going to be made out of 4140 chromoly and be hardened. It looks like they'll be around $250 a piece, but that's not set in stone.

Let me know how many are interested.

-Greg

 

[metalmacguyver]

Thats not a bad price. Too bad I already have one.

 

[small ranger]

I might be interested. Keep me in mind. I need to figure out if a regular doubler shaft will fit my doubler adapter plate.

 

[maddyn]

So we got this back from the machinist the other day...

and we need to get a few issues addressed with fitament, then its off to the heat treatment place. They're still sitting at $250 a piece for the shaft if we get 10 ordered.

Let me know who's interested

 

[maddyn]

I might be interested. Keep me in mind. I need to figure out if a regular doubler shaft will fit my doubler adapter plate.

We're figuring on a 1/2" adapter plate with the length of the shaft

 

[CheapThrillB2]

i would, but to rich for my blood

 

[jon_p_day]

I am fixin to put a doubler in my truck I am using my tranfer case out of my 83 ranger 4 speed and I bought a 86 ranger v6 automatic and was going to use them so will it work with mine I have put toyotas transfer cases togather but not rangers I am a little skiddish of doing it what all do I need?