dig deep guys

[TRUNK_MONKEY]

need a trans with a low first gear.
saw pinto engines adapted to early willys with t90 trans w d20 xfer case.same engine family as the 2300cc right?
novak makes an adapter for the t90/d20/pinto engine,i would like to know if this can go to the 2300cc "modern" engines?or even the 2500cc as well.i think a t90 is more than up to the task for this engine.
i am off to see what Klune offers the ford enthusiast!

 

[TRUNK_MONKEY]

anyone here use a Klune V?

http://www.klunev.com/apps_manual_new_page_2a.htm
i will have to look into that as well.the klune will fit the 6 bolt pattern of the BW xfer cases,perhaps that will get it lower.but damn they are not cheap.but they are bombproof for sure.