diff and pinion bearing removal?

[85broncduece]

ok i tried the bearing puller/bearing knife, wont budge. any ideas yall?

 

[Explorin94]

If the bearing is junk....air hammer

 

[85broncduece]

ill give that one a whirl. thanks.

 

[Stangman92]

I had a bad pinion bearing on a mustang once, i put the whole axle under a 12 ton press and it didnt move, if the air hammer doesnt do it a sledge hammer will. Good luck

 

[pillen140]

are you talking about after you took the carrier out and pinion out, removing the races? or removing the bearing from the pinion itself? if so, press and bearing separater. a shop will usually do it for a couple dollars if you bring just the pinion in.

 

[85broncduece]

air hammer wrked out. It was the bearings I was fightin with, The seperator wouldnt budge em, but the air hammer with a curved chisel worked b*tch*n no tooth damage and bearing is still intact for a mock up bearing, thanks every one, now I just gotta stick this thing back together, and back under the bII.