I believe that there is a thread on here about a member filling and refinishing a first gen dash pad, with good results. A "search" of this site would probably bring it up.
I bought a pre-fab dash cover for mine. I'm drawing a blank on what brand it was (CoverCraft, CoverKing, something to that effect).
There were a few challenges finalizing its fit (mostly getting the vent registers to look correct), but in the end it came out pretty decent (much better looking than the cracked dash underneath).
For
a small yearly donation, you can support this forum and receive a 'Supporting
Member' banner, or become a 'Supporting Vendor' and promote your products here.
Click the banner to find out how.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.