bottomdollarjack
Member
- Joined
- Apr 20, 2009
- Messages
- 17
- Vehicle Year
- 1994
- Transmission
- Manual
Changed buttons on 98 ranger,cruise indicator light now blinking, horn stays blowing when tighten airbag bolts down,what gives
-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
Cruise control
- Thread starter bottomdollarjack
- Start date
- Joined
- Feb 28, 2001
- Messages
- 9,583
- City
- Dayton
- State - Country
- OR - USA
- Vehicle Year
- 1990, 1997
- Drive
- 4WD
- Engine
- 2.3 (4 Cylinder)
- Transmission
- Manual
- Total Lift
- 6
- Tire Size
- 35"
I'm curious how this turns out, my '00 Explorer one day the horn started honking when I hit the CC buttons and then it blew the fuse, I changed the fuse and the CC will work ONCE then blow the fuse and the horn hasn't worked since that day like 2 years ago...
- Joined
- Dec 16, 2016
- Messages
- 1,199
- City
- Denver
- Vehicle Year
- 2009
- Engine
- 4.0 V6
- Transmission
- Automatic
Clearly there is a short somewhere in the steering wheel area. The most likely culprit is the clockspring as those things are pretty touchy, but it could be that your "new" switches are bad. Did you check the ohms of them before you installed them?
Sponsored Ad
Sponsored Ad
TRS Events
Member & Vendor Upgrades
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
Recently Featured
Ranger Adventure Video
TRS Merchandise
Follow TRS On Instagram
