clutch slave wont work

[black_demon69]

ok 94 ranger 4x4 mazda trans new flywheel, pilot, release bearing, clutch, slave, master. it will not actuate slave. there is no air system has been bled to where if bleeder is open and you depress peddle fluid squirts out with no bubbles... question is where to go from here?

 

[BRUTUS_T_HOG]

You need to remove the master and line and bleed the air out of the line. Look it up on YouTube to find how to do it. If you don't do this procedure you will NEVER get it bled. Be wasted 4hrs before I knew this technique now I go straight to the finish line done in minutes

 

[black_demon69]

thanx got it bled removing the master was the key