having issue getting hydraulic line back into slave. any ideas? '93 3.0 m5od. am re-using slave no issues with unit only had in service for two years.
Last edited:
-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
clutch hydraulic line
- Thread starter basketranger
- Start date
Cadger
Active Member
Was it the newer style connector with the removable clip, or the older style with the white collar you have to slide to release?
older style with white collar.
06RangerXLT
Well-Known Member
pull your white collar back, lube the rubber O ring and try it again. is be careful about any bleeders being open, air travels up remember.
Kloque
Member
- Joined
- Nov 18, 2011
- Messages
- 16
- Vehicle Year
- 1994, 1991
- Transmission
- Manual
Yeah you should have your resevoir's lid off so fluid drains down and out, just like doing a gravity bleed. Shouldn't hurt anything, just so no one pushes the clutch while its open, and the lids off so there is no vaccum.
Sponsored Ad
Sponsored Ad
TRS Events
Member & Vendor Upgrades
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
Recently Featured
Ranger Adventure Video
TRS Merchandise
Follow TRS On Instagram
