Clutch advice

[97ranger11]

So the throwout bearing in my truck is making a lot of noise so I figure I will go ahead and replace the clutch and slave as my truck has 150k.

I'm looking at the clutch kit and slave below.
Sound good? Is there anythingelse I need?

http://www.rockauto.com/catalog/moreinfo.php?pk=4698552&cc=1138148
www.rockauto.com/catalog/moreinfo.php?pk=4696086&cc=1138148

 

[95MEXIFORD]

Just be sure to take a good look at the flywheel and pilot bearing.

 

[97ranger11]

Just be sure to take a good look at the flywheel and pilot bearing.

yeah I think the kit comes with a new pilot bearing. My clutch as it is works fine so hopefully the flywheel will be fine.

On another note, am I okay using a aftermarket slave cylinder? I read on another forum to only use a ford slave cylinder (which is like $130 vs $60) though I have seen people recommend the luks.

 

[95MEXIFORD]

Not sure. I went with a Duralast part ($60)from autozone that comes with a lifetime warranty. But on the other hand, I have had to replace it a few times.

 

[97ranger11]

that sucks

 

[ab_slack]

I don't like the autozone brand (duralast)

I was going to say don't forget the pilot bearing. I think I have one that isn't doing so well causing some of my shifting problems. I don't think it got changed when my clutch was done.