• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

Cliff's Hangover Run- Jan. 1st- Marsielles, IL


We are wrenching away planning on that too. I need to swap transfer cases still and my buddy has to finish his 'Yota. Things are looking like we will make it though.
 
I wont be able to make it on new years, but i would really like to plan a trip mid jan. Maybe the 16th or 17th.

How far away are you guys from the cliffs again?
 
I'm an hour and half.
 
I'm just over an hour away. Now I don't know if I can get my truck ready by then, to much shit to do and not enough time.

Have had one nasty cold the past week kickin my ass, and it's been to frickin cold outside to work on it. Wish I had an empty garage to work in... damnit!

I'll probably just end up goin fishin instead.


.
 
Nonsense poopy pants!!

You must be getting old now, fishing or wheeling?


But I guess since its so cold out I don't blame you at all. Hopefully the weather will straighten up so we can even run.
 
"Poopy pants"??? Damn kids anyway... :annoyed:


I have more fun fishin than wheelin with my kid these days. And if I break a rod or reel, I can sit on my ass in the warm house and fix it! So, yeah, I'm gettin old... :icon_thumby:


Weather might be a factor, looks to probably be sloppy for sure and make some tough going on the trails.


.
 
Just messin' with ya, nice sig by the way. I'm sure if you break a rod and reel, it would be much easier on the back pocket!
 
is this happening for sure? i would like to go wheeling on the 1st, but don't want to drive 3hours unless i know for sure this run will be happining. i tried calling the cliffs, but i don't get an answer.
 
I need to put my transfer case in tomorrow afternoon, if that happens, I'm about 99% sure I'll be there sometime between 10-11am in New Years.

I can't make any promises I'll have a chance to get my transfer case in though.
 
I'm out, didn't get the parts I need to be mobile. Will be working off my hangover fishin instead.

Have fun if you guys go, post up some good pics too!


.
 
Had a pretty good day out there. My buddy didn't have his Yota buddy done yet, so we took his parts truck out and had a good time. I finally figured out my transfer case gremlin and stayed with a stock length front shaft and it worked great.

Went all morning and a little bit into the afternoon until my tranny stuck in foward. I can move the lever on the side of the trans through all the positions, but it stays locked in Drive. So, either I see if something is plugged up in the valvebody or I say F-it and swap in the 5-speed I have laying out back.

Pics to come soon...
 
it was very cold, esp for this poor kid.

3161299492_ecf7e5c96d_o.jpg


who ended up on the wrong side of this atv:

3161303152_b2d052a877_o.jpg


then his dad jumped in to get the atv out:

3160469495_3158e291ed_o.jpg


my brother stuck in a ice mud hole:
3160459265_d26748010b_o.jpg


3160454121_07a9420d88_o.jpg


the hills were very challenging because of the frozen mud which was very slick.
3161283666_e105df1edd_o.jpg
 
I didn''t realize you where the guys where the ones who helped jump my buddy's Yota in the parking lot.
 

Sponsored Ad


Sponsored Ad

TRS Events

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Ranger Adventure Video

TRS Merchandise

Follow TRS On Instagram

TRS Sponsors


Sponsored Ad


Sponsored Ad


Amazon Deals

Sponsored Ad

Back
Top