justbinfishin
Well-Known Member
- Joined
- Jul 22, 2011
- Messages
- 59
- Vehicle Year
- 1993
- Transmission
- Manual
This has been done to death, but I have one question I couldn't find in the search function. I have new Moog +/- 2 degree camber bushings. I know where they go/how to install them. However, the pinch bolt that holds the bushing in place has a strange head design I haven't seen before. Kind of a 12 point scalloped design. Am I supposed to tap in the same size 12pt socket or is there a special tool for this bolt? Given the bolt's recessed location I'd rather not try and round it off if I need a $2 wrench!
I just replaced my wheel bearings, coil springs and shocks so this is the last thing before she gets an alignment.
Thanks!
Justin.
I just replaced my wheel bearings, coil springs and shocks so this is the last thing before she gets an alignment.
Thanks!
Justin.