Hi guys, I just lifted my 1989 2WD 2'' with coil spring spacers up front and blocks in the rear. The camber on the front is positive and very noticeable. I was luckily able to pull the stock camber bushings out, they are not the eccentric ones, they are the 0 degree ones. Does anyone know what angle bushings I need for the 2'' lift and where is the best place to get them? thanks.
-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
camber bushings
- Thread starter Cole
- Start date
- Joined
- Oct 24, 2012
- Messages
- 5,094
- Points
- 1,601
- Age
- 36
- City
- Lafayette
- State - Country
- TN - USA
- Other
- 1978 Honda XL350 12v & Electronic Ignition Swapped
- Vehicle Year
- 1988
- Vehicle
- Ford Ranger
- Drive
- 4WD
- Engine
- 4.0 V6
- Transmission
- Manual
- Total Lift
- 4"
- Tire Size
- 245-70-R16
That would be determined by how far out of alignment you are now...
I'm happy with my adjustable bushings though.
I'm happy with my adjustable bushings though.
Sponsored Ad
Sponsored Ad
Special Events
TRS Events
Member & Vendor Upgrades
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
Recently Featured
TRS Latest Video
TRS Merchandise
Follow TRS On Instagram
