Bronco II extended radius arm picture request....

[mjonesjr]

I am looking for a picture of the rear mounting bracket for the Superlift or any other style extended radius arms.....i need to know where they mount at on the frame.....

 

[thebison]

i did this for ranger, this is where i mounted mine should be similar to yours if you plan on doing this. http://www.therangerstation.com/forums/showthread.php?t=13907

 

[prerunnerrunner]

check www.camburg.com

 

[mjonesjr]

i did this for ranger, this is where i mounted mine should be similar to yours if you plan on doing this. http://www.therangerstation.com/forums/showthread.php?t=13907

i actually have extended radius arms and their mounts.....i just need to know where to put them....

 

[Toreadorranger]

i actually have extended radius arms and their mounts.....i just need to know where to put them....

Whip out the measuring tape...

 

[mjonesjr]

Whip out the measuring tape...

that is the smartest thing i have heard all day.....i have done that genious....i want to see a picture of where on the frame it mounts......

 

[Toreadorranger]

Then whats the picture for? If you had the measuring tape out you should know exactly where it goes.

 

[mjonesjr]

if you have no picture, get lost....i don't have to explain anything to you....

 

[Toreadorranger]

if you have no picture, get lost....i don't have to explain anything to you....

Easy there I was just wondering what the problem was? No need to bring your additude from RF to here.

 

[Dishtowel]

soooo homemade radius arm mounts are no interest to you?

 

[mjonesjr]

no i am using the Superlift radius arm mounts.....i know they mount infront of the transmission crossmember on a Ranger, but i cant seem to figure it out for a Bronco II....are they the same mount between the two models?

 

[Dishtowel]

well they are mechanically the same as far as I know, they use the same engine and trans.... so, yes, I would say with significant certainty that they mount in front of the trans crossmember. remember that B2's have a 94" wheelbase, so clamp it together how you think it should go (in front) and measure from front hub to rear hub. If u put it behind the trans crossmember that would be approx 6-7" different, I'm sure you would notice. It probably doesn't even look right.

 

[Dishtowel]

Success?

 

[mjonesjr]

i am installing them today...