Blackwidow reborn

[RangerFabWorks]

 

[RangerFabWorks]

 

[RangerFabWorks]

So incase the video didn't show it. The block is trash. It's been punched .040 over already. The cylinder walls are toast. The crank is shot. It had a terrible rebuild. So a new motor is in order!

 

[RangerFabWorks]

And that's what I got!






So it's a 96 f250 351w. Low miles. It is a roller block. Ran good. Grabbed it from my local yard for 350 bucks as you see it. So we're back on track!

 

[RangerFabWorks]

bump

 

[RangerFabWorks]

I would love to say that i am completing the 351w swap. but i changed directions with the truck again. still going to be 400 horsepower and stick. but it may not be blue.........

 

[adamshadow2008]

So,what are you thinking engine wise? Buddy of mine is doing a 2jz swap into his foxbody right now. That'd be a fun ranger

NYC was a blast by the way man.

 

[ford4thot]

So,what are you thinking engine wise? Buddy of mine is doing a 2jz swap into his foxbody right now. That'd be a fun ranger

NYC was a blast by the way man.

I love that swap!! Gonna get so much hate

 

[RangerFabWorks]

Ill let the pictures do the talking. most of trs knows what ive done for engine swaps before.................

 

[adamshadow2008]

So I am guessing chevy like before. Small or big block?

 

[RangerFabWorks]

So I am guessing chevy like before. Small or big block?

400 horse 350 small block with a super t10 backing it up

 

[adamshadow2008]

400 horse 350 small block with a super t10 backing it up

I am sure the haters will be soon on you again. What did/are you doing to get 400 hp out of it? I have an old corvette with a 350 that is too slow could use the help.

 

[RangerFabWorks]

I am sure the haters will be soon on you again. What did/are you doing to get 400 hp out of it? I have an old corvette with a 350 that is too slow could use the help.

Let em hate lol. i dont care.

started with a goodwrench 350 short block. got a set of vortec heads. milled them to bump the compression up. did some pocket porting and polishing. used a lunati 61003 camshaft. edelbrock high rise intake. and edelbrock 750 carb. made 389 horse on the dyno. its a mean set up

 

[Mark_88]

And that's what I got!






So it's a 96 f250 351w. Low miles. It is a roller block. Ran good. Grabbed it from my local yard for 350 bucks as you see it. So we're back on track!

I just had to look...

Now I might have to look in more often...

 

[adamshadow2008]

Let em hate lol. i dont care.

started with a goodwrench 350 short block. got a set of vortec heads. milled them to bump the compression up. did some pocket porting and polishing. used a lunati 61003 camshaft. edelbrock high rise intake. and edelbrock 750 carb. made 389 horse on the dyno. its a mean set up

Are there any issues with high rise intakes and hood clearance with these mini trucks? Are you still rocking the stock hood?