BII Rear Bumper

[1989Bii]

Here it is....

I started grinding the welds down...

I got the holes drilled and then pull it back off to paint the rusted metal around the gas tank.

Here are the other pictures from the front bumper

The light mount...

Frame mount....

Later on next week i am going to get some stronger bolts and probably put a third hole in it.

 

[compaqeo]

Nice job are those 3/16 or 1/4 plate? Are those front offroad lights Piaa's?

Oh would probably fit in the Fabrication forum better.

 

[disciplerocks]

Very clean. Does your spare cover your license plate where its at? I need a new place for mine and haven't found a good spot.

 

[88_Eddie]

looks good, i'm planning on building almost the same thing on mine in a few months. i wanna add some lights, d-rings and probably a new spare tire mount......nice work

 

[1989Bii]

I used 3/16 steel for the front and rear bumper. BTW the license plate is bolted up to the spare tire cover for now until i find a spot on the bumper, or tailgate.

 

[CountryBoy78]

Nice looking bumpers. Clean and simple designs.

 

[WesB]

Nice, I wish I had a welder and fab skillz.