bed liner

[91rangerxlt]

well i was thinking about taking my fenderflares off, and putting some bedliner material over where they used to go, so it will look like a fenderflare but be flush with the body and not sticking out, how would i go about doing this?

 

[greasemonkey6886]

best way I could think of is before you take them off use a sharpie marker to mark the outside edge of them on the body. Then after removal just follow the instructions on the can of bedliner you are going to use. Just make sure when you scuff the paint up for proper adhesion that you dont remove the sharpie line. After scuffing just use painters tape and tape along the outside edge of your lines and bedline away.

 

[strvger]

if you're planning on using the rattle can bed liners, save your money. the spray can stuff is way thinner and won't last nearly as long as the roll/brush on Herculiner or Road Warrior in the gallon cans. just my $.02.

 

[daniel3507]

You have to find way to fill in the holes that are there once the flare is off.