• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

98 Mountaineer Unbalanced noise


WisdoM

Well-Known Member
Joined
Jan 2, 2009
Messages
159
City
So Cal
Vehicle Year
1993
Transmission
Manual
I’ve got a 98 AWD Mountaineer (wife’s DD) anyway the beast makes a noise like an unbalanced tire in the front when it gets to 50mph…you can’t feel the vibration but you hear it. I’ve had the tires re-balanced, had the rotors checked and just generally looked at everything under the front with no luck…any ideas what to check?
 
Not sure that this is it but I will relay my experience with a 1990 Explorer. I had to take it in to a axle shop toget the seals on the rear axle replaced. During this time they change the U joints. When I drove the truck it had a vibration at about 60 MPH. I went back and the shop indexed the drive shaft and the vibration was reduced. However, to solve the problem I went to the Ford dealer and after arguing with them they replaced the drive shaft. They picked up the labor but I paid for the part at $400.
 
I was thinking that it might be one of the CV's going out? is there a way to tell without pulling apart?
 
I know on my B2 if a bearing is on its way out it howls a bit and if it gets really bad the tow-in on the affected tire will get visible / tire sorta slants out at the bottom if you were looking at it from the front straight on. I dunno if CVs do that though, I would imagine it is a hub assy going bad from the noise you describe. The hub assy houses the bearing on your truck. I did one on my msisters 97 explorer it was about $100 to replace and took about an hour to do.
 
So if the hub is going out wouldnt there be play in the wheel like a traditional wheel bearing?
 
So if the hub is going out wouldnt there be play in the wheel like a traditional wheel bearing?

Yes. The IFS Explorers and Rangers have a sealed hub and bearing assembly. They make a characteristic howl at speed when they start going bad, and they go bad enough that I can tell you you will need a 32 mm, 19mm, 15 mm, hammer, and chisel.

Sometimes they start to make noise before they get play though.
 

Sponsored Ad


Sponsored Ad

TRS Events

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Latest posts

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Ranger Adventure Video

TRS Merchandise

Follow TRS On Instagram

TRS Sponsors


Sponsored Ad


Sponsored Ad


Amazon Deals

Sponsored Ad

Back
Top