• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

86 bronco II and 86 ranger suspension questions


Spenser

Member
Joined
Aug 24, 2012
Messages
9
Vehicle Year
1986
Transmission
Manual
im thinking about buying my buddies bronco because it has more parts but the ranger does have the running motor and 6 inch lift im wondering if i can take the suspension and swap it over or at least most of it, and any ideas for a driveshaft its all stock axles right now on both vehicles
 
Suspension parts should all swap fine.

If the BII has a manual trans (FM145), the front driveshaft from a '91-'97 Ranger ('91-'94 Explorer) can be used as a rear shaft on the BII (just need the t-case output yoke and a rear flange for it).
 
thank you for the help, my friend told me what it was but i forgot, its auto locking hubs
 
ewwwww auto hubs i think i just threw up in my mouth scrap them for man. habs
 
plan to if i get it the ranger has manual locking hubs, its hard to pass up for only 300$
 

Sponsored Ad


Sponsored Ad

TRS Events

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Ranger Adventure Video

TRS Merchandise

Follow TRS On Instagram

TRS Sponsors


Sponsored Ad


Sponsored Ad


Amazon Deals

Sponsored Ad

Back
Top