7.5 locker install

[badmts]

I was looking in the tech section and did not find the tech article that talked about grinding a tooth on 4.10 and larger gears when doing a lunchbox locker on a 7.5.I have 4.56 gears now and want a locker next month but I need to find good instructions for the tech here at work so we grind the right tooth!

 

[4x4junkie]

Nothing real difficult about grinding it... Only tooth (teeth) to grind are the one(s) blocking acces for the cross pin (if one side looks like it might take less grinding than the other to get it in, grind on that side). Grind as little as needed just to allow the shaft past.

More info here:
http://www.therangerstation.com/forums/showthread.php?t=92047&highlight=grinding+gear