4x4 switch

[Brango]

I have a 1988 Bronco II i just recently bought it back and most of the interior got ripped out including the 4x4 push button, and half the wiring. Does anybody have a wiring diagram for it? And is it possible to make it work with toggle switches or push buttons?

 

[Josh B]

That's probly about all those pushbuttons are Brango, fancy toggle switches, each one moves it to the next position(or back), but you'll surely get a more detailed answer in time.

 

[RonD]

Welcome to TRS

With an ON|OFF|ON toggle yes, it tells the 4x4 Module what you want, 2WD, 4High or 4Low
OFF would be 2WD, each ON would be either 4H or 4L you choice

There is a 4x4 control module behind a panel on the passenger side dash, thats what really runs the 4WD

 

[Brango]

Welcome to TRS

With an ON|OFF|ON toggle yes, it tells the 4x4 Module what you want, 2WD, 4High or 4Low
OFF would be 2WD, each ON would be either 4H or 4L you choice

There is a 4x4 control module behind a panel on the passenger side dash, thats what really runs the 4WD

Do you know where i can find the wire colors for that, they basically just cut everything out.
So only need one toggle switch

 

[RonD]

If they cut everything then you will need this: https://www.ebay.com/itm/OEM-Repair...ruck-Ranger-Bronco-II-Evtm-1988-/282314097873

You need a year and model specific EVTM, it will have every wire and where it is for that year/model and all options
These are made by Ford and sent out to Ford Shops for every model, every year, its part of the shop manual set

 

[Brango]

Thank you for the help hopefully I can get this all taken care of soon and finish out the truck