ok looking @ doin this swap in my 89 b2 and HATE wiring and was wondering if i swap the xploder dash into my b2 would that make the wiring easier or just the same?
-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
4.0 ?
- Thread starter twoll86
- Start date
Clem
Well-Known Member
Try this article:
http://www.broncoii-ranger.com/forum/viewtopic.php?p=9135#9135
The dash from the 91-94 Explorer are the same as 89-90 B2. I swapped a 90 B2 dash into my 86 B2 after swapping the wiring harness, (found out later that was not necessary).
Ray
http://www.broncoii-ranger.com/forum/viewtopic.php?p=9135#9135
The dash from the 91-94 Explorer are the same as 89-90 B2. I swapped a 90 B2 dash into my 86 B2 after swapping the wiring harness, (found out later that was not necessary).
Ray
Last edited by a moderator:
wont i still have to do some wiring would swaping the dash limit this?
TheOne
Well-Known Member
i was also under the impression that if u swap the dash it should all be plug and play with very little wiring no? 
what i thought also
Sponsored Ad
Sponsored Ad
TRS Events
Member & Vendor Upgrades
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
Recently Featured
Ranger Adventure Video
TRS Merchandise
Follow TRS On Instagram
