Welcome Visitor! Please take a few seconds and ddgssg
New Member
- Joined
- Feb 26, 2014
- Messages
- 4
- Vehicle Year
- 1999
- Transmission
- Automatic
Good afternoon. I have a issue. My 99 ranger lost power it had no compression on the #6 cup. I found a hole in the piston. The cyl had lots of aluminum on it but it honed out real good. I have a new std piston but cannot determine the connecting rod install to the piston. I thought it was with the bump on the rod onboard but on the in the #1 cyl has it towards the crank every other cylinder it is to the right side. Any ideas on the placement? This goes in the #6 spot.
