2.9 wont start

[THETROOPER]

Hi all. I'm working on this truck and its killing me. I had it running and then I went to flush the radiator and wound up replacing it. while filling the new radiator the truck died. Now it wont start. I've replaced cap and rotor plugs and wires, coil, icm. The plugs are getting spark. I'm getting fuel to the fuel rail. I just tried starting fluid and the engine fired and burned off the fluid then died. My next plan is to pull the injectors. Any other suggestions.

 

[Psychopete]

Sounds like the computer is not grounding the injectors, but a noid light would verify. Also check for 12v at an injector to make sure there's power (they're hot with key on run). Can't guess at anything specific, but I don't think your injectors themselves are the problem - if that at least can save you some time...

Edit, I should also mention that this is a batch fire setup, 3 injectors spray at the same time. 2 wires to control the 6 injectors.

 

[THETROOPER]

Ok so I pulled the connector that leads to the injectors and i only got 3 volts. Do I need to check directly at a single injector?