koochman450r
Member
Will a 1988 trans from a 2.3 bolt to a 1996 2.3? As in bellhousing pattern and clutch/ flywheel compatibility? Any help would be appreciated. I can't search the forum on my phone so don't harass me too much. Thanks.
-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
2.3L transmission ?'s
- Thread starter koochman450r
- Start date
- Joined
- Feb 28, 2001
- Messages
- 9,583
- City
- Dayton
- State - Country
- OR - USA
- Vehicle Year
- 1990, 1997
- Drive
- 4WD
- Engine
- 2.3 (4 Cylinder)
- Transmission
- Manual
- Total Lift
- 6
- Tire Size
- 35"
it will fit and is the same other than possibly a couple details you could compare. For one, the slave cylinder is different between the two and am not 100% sure on compatabiliity on them but I think it'll work as long as you get the right one for the transmission. The other issue is you will need to look at the speed sensor in it, a '96 speedometer isn't driven by a cable anymore but I think there is still an electric sensor, no idea if it's where the speedo gear is though...
Sponsored Ad
Sponsored Ad
TRS Events
Member & Vendor Upgrades
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
Recently Featured
Ranger Adventure Video
TRS Merchandise
Follow TRS On Instagram
