Welcome Visitor! Please take a few seconds and 
OkayKafka
Well-Known Member
- Joined
- Mar 23, 2016
- Messages
- 62
- City
- Seattle
- Vehicle Year
- 1987
- Engine
- 2.3 (4 Cylinder)
- Transmission
- Manual
I got this truck a while back and I've been rehabbing it slowly. I started to work on it and try to get things to run better but in the process I've gotten it to run rough than before.
I've replaced my EGR and MAP sensor and cleaned the IAC: but the motor still runs rough and wants to stall.
The only thing I haven't done is go through the fuel system. I did get a KOEO code of 87 so I know that there's something wrong. I just don't know anything about electronics.
https://www.youtube.com/watch?v=nFG20JAQ_GY&feature=share
The truck has been sitting since about May of this year with it only running at idle in the driveway. Should I just go out and drive it after I've replaced parts and reset the ecu?
Sent from my iPhone using Tapatalk
I've replaced my EGR and MAP sensor and cleaned the IAC: but the motor still runs rough and wants to stall.
The only thing I haven't done is go through the fuel system. I did get a KOEO code of 87 so I know that there's something wrong. I just don't know anything about electronics.
https://www.youtube.com/watch?v=nFG20JAQ_GY&feature=share
The truck has been sitting since about May of this year with it only running at idle in the driveway. Should I just go out and drive it after I've replaced parts and reset the ecu?
Sent from my iPhone using Tapatalk
