Welcome Visitor! Please take a few seconds and 
- Joined
- Mar 8, 2008
- Messages
- 158
- Age
- 61
- Vehicle Year
- 1986
- Transmission
- Manual
1st of all. THANK YOU JORLEY for getting my pics in my post
this is the start, unfortunately most of what i am going to do wont be seen. 
i have already made a free flow air intake that i will make a snorkel through the hood for. but other than that, going to get a 9000# winch.(no not a fat chic) i want to do the Dana 35 up front, the 10" clutch conversion, and 4.56 gears at same time, i would like to get rid of 3" body lift and go to a 4" suspension lift. i already put a freer flowing muffler the cat is already free flowing one. would like to get a "roll bar" in the bed that i will attach to the frame,( for what i do that will be good enough). 
here is where i post all my pics
http://www.flickr.com/photos/dchadwick1063/sets/72157603963505642/
1986 ext cab ranger
2.9 L with the 145 trans
3" body lift
32x11.50 bfg all-terrains
this is the start, unfortunately most of what i am going to do wont be seen. i have already made a free flow air intake that i will make a snorkel through the hood for. but other than that, going to get a 9000# winch.(no not a fat chic) i want to do the Dana 35 up front, the 10" clutch conversion, and 4.56 gears at same time, i would like to get rid of 3" body lift and go to a 4" suspension lift. i already put a freer flowing muffler the cat is already free flowing one. would like to get a "roll bar" in the bed that i will attach to the frame,( for what i do that will be good enough). here is where i post all my pics
http://www.flickr.com/photos/dchadwick1063/sets/72157603963505642/
1986 ext cab ranger
2.9 L with the 145 trans
3" body lift
32x11.50 bfg all-terrains
Last edited:
well i scored a new xd9000i warren winch, on a slide mount. the cable kit for the winch. a slide hitch off a newer ranger for the front(might have to modify truck not here) dont know if frame same size. 
