• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

04 ranger makes weard noise


wvfarmer

Member
Joined
Jan 16, 2011
Messages
17
City
hillsboro wv
Vehicle Year
03 ranger 4x4
Transmission
Manual
My credo
me
04 ranger 4.0 auto trans in 4x4 makes a loud clunking noise a bout ever thousand feet in 4x4 only its like sonething is catching and leting loose, all 4 tires are the same size it has had anouther rearend put in not long ago dont think its comming fron the front end we have check all axels and drive shafts has any one had a similar problem dont do it in 2 wheel drive has around 145k showing any ideas???
 
I would make double dog sure that rearend that was swapped in is the correct gear ratio. Don't take anyone's word for it, check it yourself.
 
Are you driving on pavement when this happens?
 
That's your whole problem. Don't use 4wd on dry pavement like that. It's a part time system that isn't engineered for that use.
 
yes on pavement, pritty sure its transfur case bad chain real loose
DO NOT use full time 4x4 on pavement! It binds up the transfer case and will break something... If it hasn't already. There are some systems that allow "4x4" use on pavement, but I don't know if yours is one.
 
DO NOT use full time 4x4 on pavement! It binds up the transfer case and will break something... If it hasn't already. There are some systems that allow "4x4" use on pavement, but I don't know if yours is one.
your rightand i know better aswell i work part time in a garage and its a customers truck i was helping trouble shout it turns out transfer case is bad
 
I disagree with the 4x4 not being used on pavement. Yes, on most all 4x4's, making a tight turn on pavement is a bad idea. But just driving straight down the road with slight turns should not be a problem.

What am I supposed to do when there are snowy or icy patches on the road? Keep shifting in and out of 4x4 as I am driving on dry pavement, and then snow on pavement?

From my experience, what most people call "full time" 4x4 systems are designed to run on pavement. They have special transfer cases with a set of spider gears inside the case, or they have viscous couplers that divide the power front to rear all the time.
 
You can do that with a full time system, yes.

These aren't full time systems.
 
You can do that with a full time system, yes.

These aren't full time systems.
Part time 4x4 systems can be run on pavement, as long as you do not make tight turns. Don't wait till you are in the ditch to activate your part time 4x4 system.
If you are in town where speeds are slower and you will be making lots of turns, I would take it out of 4x4.

If you are on the interstate or a back road, the pavement is dry and then patchy snow and then dry again, there is nothing wrong with leaving the part time 4x4 active.
 
You can generally get away with it on dry pavement if you're only moving in a straight line. But it's not good practice for obvious reasons.
 

Sponsored Ad


Sponsored Ad

TRS Events

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Ranger Adventure Video

TRS Merchandise

Follow TRS On Instagram

TRS Sponsors


Sponsored Ad


Sponsored Ad


Amazon Deals

Sponsored Ad

Back
Top