tk4

Bought an 1984 B2 with the TK4 transmission a few months ago and I've been at a standstill with the transmission for a while now. Initially it shifted fine, clutch felt alright, though I only drove it a few minutes before it started spawning all sorts of electrical/mechanical issues that left it...

I recently picked up an 83 4x4 long bed that's in pretty good shape but has a bad motor. This thread will serve to document my progress as I slowly put her back together. I had another 83 a few years ago. I really loved that truck, but sadly severe frame rust did it in. Ever...

Hey there, I finally got a TK5 4WD transmission for my truck. Before I start tearing everything apart, I wanted to know if I could still use the same driveshaft, including the one for the 4WD. The length of a TK4 4WD transmission is 24 inches, a TK5 is 25.932 inches from what it says here on...

Hello all, been reading these forums to guide me through a throw out bearing replacement on my recently purchased Ranger. Here's whats going on : - Master cylinder was destroyed, replaced it with new unit - Slave cylinder appeared to be leaking and super old, replaced with new unit...

Are the two transmissions the same size? I know the bellhousing is removable from my truck to transplant onto the FM145. Will the drive shafts be compatible? My truck is a stock 84 b2 with the TK4 4spd manual. Looking to swap in a FM145. Thanks, 84BB2