• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

vibration

  1. Vibration at higher RPMs

    When I am driving my 2011 4.0L sport I will occasionally get a deep vibration coming from the engine starting around 2500RPM, and it gets louder as you go higher to 3000RPM. the vibration sounds like going over rumble strips, and feels like going over a slightly rough part of road (not near the...
  2. Vibration/grinding noise

    Hi, I've got a 1987 Bronco II. It's a 2 wheel drive. It runs and drives well. When I bought the truck. It had a pretty bad grinding noise when I would go from stop at a red light to take off. I figured it was either sticking brakes or the transmission. I checked the brakes, but they looked ok. I...
  3. Help please! Rear wheel hub/drive shaft play. Got bad vibrations...

    Hi! See video Because of a really bad vibration creeping up on the truck, I jacket it up and started yanking stuff. This don't look too good to me Where is the problem? Inside the differential? Exactly the same play on both sides/hubs. Could this be the reason for my vibration...
  4. 97Ranger3.0

    Vibration at 3000+ RPM ???

    Hey guys, I'm looking for some help and this is a strange one... Recently I did a bit of work to the cooling system on my 1997 Ford Ranger 3.0 XL, and after the work I now have a vibration/shudder/rumble that occurs at 3k rpm and up. What's weird about it is that prior to doing this work, I...
  5. Rough Under Load - Fuel Smell - No Codes

    Truck starting jerking a little a few days ago at highway speed and then continued even at low speed. First thought was bad fuel pressure or blocked fuel filter. While driving/under load: Heavy vibration and sometimes jerks/bucks. Feels drive train related. At idle or rev up while in...
  6. 94 4.0 5spd. Shakes when accelerating above 30mph.

    So when I drive no matter how smooth the road and get above 25 or 30 mph the truck starts to shake. The whole truck. It can be felt in the front seat and back, the steering wheel and floor. This only happens when picking up speed. Let off the gas and it goes away. Take it out of gear and it goes...
  7. 4X4 drive shaft

    I was told the drive shaft on my '05 lvl 2 has internal components (ie: inner sleeve, corrugated material) that, after taking a hard knock, can break free, thereby causing an imbalance in the drive shaft and some vibration. Is this true? Photos?
  8. '05 Level 2 126" wb drive shaft info needed.

    Hi guys, I'm new to the site and new to Ford Rangers. I purchased a 2005 lvl 2 in May. I've searched for some info regarding the drive shaft in my lvl2, 126" wheelbase but I've not been able to find what I'm looking for. Does my drive shaft have internal components? ie: inner sleeve...
  9. Truck Vibration

    2000 2wd 3.0 flex fuel I am getting a vibration in my truck on the highway. the steering wheel shakes but the truck does not pull left or right. Seems to start at 45 55 at higher speeds it seems to really vibrate fast and hum. Replaced rear shackles upper and lower control arms, wheel...
  10. Mazda B4000 Vibration

    Help needed please, I replaced U-Joints, Carrier Bearing, marked the driveshaft so I put it back together correctly and now I have a terrible vibration. At low speeds (15-35 mph) it feels like the rear end is hopping. At 45+ mph the entire truck goes into what feels like space shuttle re-entry...
  11. Rangurr

    Just an idiot teenager who ruined his truck...

    I apologize in advance for writing a novel on here but hopefully most of the information is helpful in finding my problem. If not, I'm sure it will at least help explain why things are the way they are on my truck. The short version: I was an idiot teenager when I did the work. Basically, I got...
  12. Mazda b2300 spindle/bearing issues and rotors don't match parts store inventory.

    Hello everyone, I am new to the forum and have been poking around on here for a while trying to come up with something to match my issue. With no luck and tired eyes I am posting for some advice. I have an 02 B2300 2wd that I bought about 6 years ago. One year in and the 3:73 rear end went...
  13. Vibration!

    Okay. I have a 93 ranger 4.0L with AT. The trans took a dump so my brilliant cousin swaped it out for a used junk yard trans. It works but thats about all I can say for it. My biggest complaint is a vibration when the truck is somewhere between approx. 28-35 mph. Once beyond the 35 mark it is...
  14. subydrift

    2004 2.3L Auto Ranger XL trans issues

    So I've got some issues happening with my trans and I'm hoping some of you guys can help me out on what it might be. I've driven manuals my whole life and this is my first auto (that's had problems anyway). The truck is an 04' Ranger XL, 2.3L Duratec, Auto trans, 162k miles. Problem 1...
  15. one piece drive shaft swap

    I have an 88 Ford ranger 2.9 L super cab 4x4. The truck has been lifted excessively and is in desperate need of the one piece drive shaft swap. Locally I have not been able to source one. I found one in a salvage yard in Phoenix (about 150 miles away) out of a 2003 ranger, 4x4, extended cab...

Sponsored Ad


Sponsored Ad

Top