• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

spark plugs

  1. stamina

    2.9l v6 spark plug replacement

    i am having a very hard time figuring out how to get to the passenger side plugs on this motor, they are in quite precarious positions. any and all advice and info, specifically on the passenger side plugs as mentioned, is very much appreciated
  2. stamina

    what kind of spark plugs should i use for a 2.9L v6 motor

    i honestly just want to know which plugs are the absolute best ones that i could possibly use for this old motor, it’s a 1990 2.9l auto 4wd. not afraid to shell out a little extra just want to know which ones are the best of the best for this lil v6💪🏼💯
  3. 98 Ranger Spark Plugs (confused)

    I'm needing to change plugs on a newly purchase 98 3.0 Ranger. After looking through spark plug threads, I'm deciding to stick with Motorcraft. Problem is, I'm getting different Motorcraft plug numbers depending on where I check. A couple of spots reference AWSF32PP as the OEM plug. This...
  4. '99 ford ranger 4.0 v6 starts and shuts off .

    Hi guys first i want to thank you for all the help that i can get i have a 1999 ranger 4.0 v6 2wheel drive with manual transmission, today i drove to my dads house 5 minute away, when it was time to go back home i start the truck put it in reverse and i was able to move it back a little than it...
  5. Massive Vacuum Leak

    I have a 2002 Ford Ranger XLT 2.3L. Today's project was simple: replace the Valve Cover Gasket, the Intake Manifold Gasket, and the Spark Plugs. Known screwups: Accidentally swapped two Valve Cover Screws (upper thread with nut screw switched with bolt screw) and only cleaned the gasket...
  6. Valve Cover Gasket Replacement - Getting Ready

    Hey, I'm going to replace my valve cover gasket, spark plugs, and spark plug wires on my 2002 Ranger XLT 2.3L, and I just wanted to see if there was anything else I should replace since I'm doing this job (i.e. replace the brake pads because you have to remove them anyways to replace the...
  7. Runs rough, plug wires, coil pack help

    I have a 1998 Ranger v6 3.0 automatic which I bought last year. It ran rough at first with shaking and then when it warmed up, fired on all six. There was also an engine code P0302 (misfire on #2). I just replaced the plugs and wires and the old plugs looked like they had a .100 gap (all...
  8. Great Deal on Spark Plugs and Wires

    After lots of reading on the forum here, the following are what I have decided to put in my '96 3.0L. Autolite Wireset #96170 for 96¢ after rebate:yahoo: price now $1.48 Autolite Double Platinum Plugs #APP104 for $2.99 each after rebate:headbang: Just wanted to share!
  9. Spark plug problems

    Help! I have an on going problem with my 2000 Ford Ranger 4.0 ltr, V6. Usually the number 4 cylinder needs replacing due to a cracked porcelain base. The last time it had a lot of oil around it. Now the codes PO174, P1151, PO306, and Cat fault are coming up. The engine light remains on...
  10. spark plug change 1998 4 cl (is it hard)

    What is the easiest was of changing the spark plugs due to location? any help would be greatly appreciated.

Sponsored Ad


Sponsored Ad

Top