rear

Looking for a passenger rear door in black in good condition. Mine is a little too far beyond repair. I have a 2004 edge supercab 4x4. Thanks! I'm located in central NJ but willing to drive a fair amount to pick up a clean one,

I have a 93 Ranger 2.3l 5-speed manual with a stock 7.5 open diff and 3.45 gears. Truck has for a long time been prone to spinning the inside wheel in a semi-sharp to sharp turn (90deg) with stock size tires. Now running 30" tires and truck handles in the rain kinda like it's snow. Taking a...

Hey, guys! First post here, been poking around for a few weeks now and figured I'd start the beginning of asking all kinds of questions. So as it says, I have a 2001 Ranger Edge and I'm wondering how wide of a back tire I can get on it, but it's a little bit more loaded of a question than that...

What I have: 1992 Ford ranger stock 4 cylinder Rear diff: 3.73 ratio, 7.5”, 2WD It has bad pinion bearings and I either need to put in new bearings or put a new axle in. I could do either but am looking for a cheap easy solution (not that a bearing swap is terribly difficult, it just sounds like...

Hi all, my truck is making a really aweful metallic screeching sound when I first drive in the morning or after sitting for an hour or more. It's not a belt or brakes I don't think because 1. It doesn't do it when stationary and 2. It only screeches for about the first 30 seconds of driving away...

So I'm doing a rear swap after mine decided to take a crap and leave everything in shreds. I can get a rear from the yard for $90 but I wanted to make sure on a couple things before I pick one up. I have a 99 ranger with a R7 rear in it. Two questions: 1. R7 is a 8.8, 4.10 rear with the...

So my current 8.8 axle is having symptoms of differential bearings going bad. It makes a bunch of noise and I have to give my truck more gas to keep it moving... Anyways, I am going to swap in another axle because rebuilding the current differential is extremely expensive. I have looked into...

Do the chevy 64 inch leaf springs use the stock ranger leaf spring bushings? I just purchased a set of polyurethane bushings for my stock springs, but then I learned about this swap and want to do it, but don't want to get rid of my new bushings

Hey, so I think I know my answer to this, but I got a Ford 8.8" axle out of a 01 ranger 4x4. I wanted to swap it into a 1997 ford ranger 2wd. Is there any kind of modifications I need to do to the 8.8 or should it just bolt straight in? I'm pretty sure it should bolt in but I understand the 4x4...

So my grandpa insisted on buying me some 6x9 speakers for my truck and I couldn't convince him otherwise so I figured I would make them work. I saw several threads on 6x9 speakers, but I thought I would show everyone my photos/experience on my 94 ford ranger standard cab. For the wiring, I just...

What's up guys. My '95 XLT Super has an open diff 8.8 and I'm considering completely redoing the drivetrain. Engine is either going to be a 302 or a 351 with gt40 heads. What I'm trying to figure out is if it would be easier to swap internals in the diff or if I should just go find an explorer...

So.... First time here. Helping my son replace the door handle/cables on the rear passenger door of a 4 door Ranger Super Cab. It's in the side of the door and the new Ford handle has a cable to the upper latch and cable and latch to the bottom. My question is; In order to remove the bottom...

I have seen other Ranger / B4000 trucks with the black wheel well molding that goes around the lip of both rear wheel openings. I called local Mazda dealer today and he said "no longer available", I could call the salvage yards but is there really no dealer inventory / ordering available for...

Hi, My '98 XLT 3.0l appears to have three catalytic converters - 1 in each downpipe, and one immediately behind where the two downpipes join. Under the hood it says this is California emissions. The flange at the rear of the rear cat has disintegrated, and I doubt it will last through the...

Does anybody make rear seat covers for Bronco II's, I found some for the front but want front and back seats to match.

I have a 93 Ranger and Im looking to get a rear tube bumper like this one. http://www.jcwhitney.com/black-textured-double-tube-rear-bumpers/p2013009.jcwx?skuId=377918&TID=froogle&06JeWrGar300242 The problem is no matter where I look, I can only find them for jeeps. I was contemplating on having...

Hey there I have an 85 BII with the auto trans and currently not moving due to a broken driveshaft, I have gone to every wrecking yard in town 5 total and every single ranger and bronco I find is missing the driveshaft, is this a common failure ? the drive shaft i have is the one with the two...

first question is i have a 99 ranger 2wd 4cyl. i'm going to gues it has the ford 7.5inch rearend i just want to make sure though. second question what is the stock gear ration? thanks for the answers

I have a 1990 Ranger 2.9 L the rear anti lock brake light comes on between 35 & 40 MPH and stays on until you turn of the ignition the in again between 35 & 40 MPH, I have done a complete from and rear break job, replace the rear speed sensor, the vacuum booster, master cylinder the rear control...