brake

So I've found a leak in my driver side rear brake line. I was planning to replace the line tomorrow so I went to put some PB blaster on it. I found that it looks like my bleeder on the brake is sheared off. Here is a picture of both rear drum brakes, one missing part of the bleeder Any advice?

HI I HAVE A SITUATION WITH MY TRUCK ABS AND BRAKE LIGHTS ARE ONE, I ALREADY REPLACE ABS SENSOR AND PIGTAIL. THE 4 TIRES ARE IN THE CORRECT PSI AND BRAKE FLUID IS FULL. COULD YOU HELP ME?

Hey guys, I have a brake light issue on my 03 Ranger XL. The brake lights come on when I move the brake light (brand new might I add, old one had same issue I'm talking about) switch up or down, but don't when I press the pedal down or do for a little bit then stops working, then when I jiggle...

Quick question for ya, I wanted to take the bronco out and finally drive the thing but I noticed I do not have tail lights or brake lights. I pulled the harness from the driver's fender back to the rear of the truck..no broken wires. I also noticed that I hear a click when I press the pedal or...

I have a 1989 Ford Ranger XLT Automatic that Only 3rd Brake is not Working! The Rear brakes function fine. The wire going to the 3rd brake light is a Black/Pink. Which on the electrical Diagrams is shown as being also used by the reverse lights. I have not been able to find any electrical...

First off I have a 1985 Bronco II 2.8l 5 speed with a 4 inch sus lift and 31 inch tires. So I have been trying to diagnose this problem since i got a new mc/power booster combo wondering if the ones I got are faulty or not. Now, I have bled the system multiple times and im pretty sure there are...

hey there I need to replace some rotted out brake lines on my truck before she goes up for sale I do not want to piss around anymore trying to get the connections out intact and just want to replace things (its cold covered in snow and Im not in a shop) there is a splitter block ontop...

Hello all, new forum member here looking for some help... I noticed when pressing the clutch down on my 2006 Ranger that the clutch pedal occasionally would make contact with part of the pedal assembly. Upon further inspection, I found that there was a little bit of lateral play in the...

I'm trying to find the rubber pedal cover pads to replace the worn out ones on my brake and clutch pedals, but can't seem to locate them anywhere. For a 2005 Ranger 5 speed 4 cyl. So far have tried RockAuto, Amazon, dealer site parts lookup, but all I keep coming up with is the rubber pedal pad...

1993 Ford Ranger XLT 3.0 V6 RWD rear right brake was leaking so badly that I had to refill one bottle each time I drove. After replacement of brake cylinder the leak stopped, but after driving I noticed right away an awful smell and then discovered that the brake was touching and causing...

The truck was taken in to the dealer for a new long block. Head cracked @ 51k. Cast block, aluminum heads. Once I got home I took off my belt and noticed the minder and Safety Belt Warning Light on the dash did not illuminate. The light illuminates when the ignition is ON like normal. Then...

Last night while working late at a job site i was adjusting the angle of my truck to shine my head lights on our work area. steped on the peddle and "pop" the line burst. i wondering how hard the job. it's burst in the articulating rubber line. can i just replace the rubber tube? or does the...

Ok so I noticed a kind of grinding noise coming from my rear wheels and I took the drums off and all the springs and everything were rusted to heck and back, so I got new springs and cylinders and drums and all that good stuff.. I replaced everything and am pretty darn certain I put all the...

Hi Folks. Picked up an 85 Ranger 2.0 (same as Mazda B) for cheap. Runs ok, but the parking break never worked. Checked it out today found that the cable was seized, and had been disconnected from the adjuster. After I got the cable moving again, I went to reconnect it to the adjuster...

alright so i installed new front pads and rotors. took my time, kept my hands off of the contact surfaces, greased everything and used quality parts. i finished the install and tested the brakes. they worked great. then after about 10 miles the screech began. i narrowed the noise down to the...

On my 94 Explorer XLT, the red brake light would intermittently stay on when I released the parking brake. I noticed it generally only happened on rainy days. I've checked the fluid in the master cylinder, and the sensor for my parking break seems to be functional (the brake light dims slightly...

So, I've had a problem with my 92 Ford Ranger Supercab XLT with ABS. About two weeks ago, I pulled over to let an ambulance pass me. I hit the brakes to slow down with no problems, but all of the sudden the brakes release and I have to push the pedal to the floor in order get any brakes at all...

When I press on my brakes, my left rear wheel locks ups for about one to two seconds, then releases. Also, it takes alot of brake pressure to get the vehicle to stop. The ABS light is NOT on, and new brakes/rotors/drums. Any ideas? 2001 Ford Ranger 3.0(not flex) 2WD Automatic Trans